X55 Public Knowledge Base
  • Introduction
  • Quick Start Guide
  • Aircraft Description & Functions
    • System Overview
    • Flight Modes
    • Failsafe
    • Herelink Controller
    • Flight Control Software
      • QGC (QGroundControl) and Arcsky Control
      • Mission Planner (PC only)
  • Setup and Operation
    • Battery Module Setup
    • X55 Setup Guide
    • Emergency Procedures
  • Accessories Integration
    • RTK Base Setup
    • LW20 Rangefinder Setup
    • Bottom Mount Battery Module
  • Maintenance
  • Appendix
    • FAA Registration & Remote ID (US customers only)
    • Precautions and Best Practices
    • Pre/Post-flight Checklist
    • Technical Dimensions
    • Performance Specifications
    • Electrical Interfaces
    • Removing/Replacing Propellers
    • Download Offline Maps via QGC (Herelink Controller)
    • Charging Flight Batteries
    • Terrain Following Using SRTM Method
Powered by GitBook
On this page
  1. Setup and Operation

Battery Module Setup

PreviousSetup and OperationNextX55 Setup Guide

Last updated 3 months ago

Place the battery on the Battery Module, and adjust the rail spacing if needed

With the front strap in place (as shown in blue), place the front battery on the Battery Module. Make sure the buckle hook points down.

Loop the strap through the middle rail as shown, and slightly tension the strap for now.

With the rear strap in place (as shown in blue), place the rear battery on the Battery Module. Make sure the buckle hook points down.

Loop the strap through the rear rail as shown and tension the strap fully.

Apply additional tension to the front strap.

Plug the battery connectors into the Battery Module XT90 ports.

Make sure the batteries are well secured and not freely movable.